ServoCity Stingray-2 Servo Gearbox (0.34 Sec/60°, 30rpm, 700 Oz-in Torque, 900° Rotation)

Title Default Title
Qty:

Description

  • ServoCity Stingray-2 Servo Gearbox (0.34 Sec/60°, 30rpm, 700 Oz-in Torque, 900° Rotation)
  • Features 700 oz-in stall torque
  • Offers 900° maximum rotation
  • Allows versatile mounting options
  • Supports both feedback and continuous modes
  • Compatible with R/C and microcontrollers

The ServoCity Stingray-2 Servo Gearbox (0.34 Sec/60°, 30rpm, 700 Oz-in Torque, 900° Rotation) is powered by the goBILDA® 5-Turn Torque Servo, featuring a 2:1 external gear ratio that enhances torque and precision while reducing the range. This gearbox is fully assembled and ready for installation, with the servo mounted to isolate the load to a steel hub-shaft supported by ball bearings, thus protecting the servo from axial loads.

The gearbox offers versatile mounting options with M4 threaded holes compatible with the goBILDA® system, and the hub allows for direct fastening to the aluminum output gear. The 8mm REX bore of the hub-shaft can accommodate an 8mm REX shaft or serve as a wire pass-through. The control signal remains identical to a standard servo, allowing it to connect seamlessly to an R/C receiver, Arduino, Raspberry Pi, or REV controller. The servo is FTC legal as it remains unmodified. Available in both feedback and continuous modes, the gearbox can switch between modes using a 3102-0001 servo programmer, thanks to the dual-mode capability of the goBILDA® 5-Turn Torque Servo.

  • 1x ServoCity Stingray-2 Servo Gearbox (0.34 Sec/60°, 30rpm, 700 Oz-in Torque, 900° Rotation)

  • Gear ratio: 2:1
  • Voltage range: 4.8-7.4V
  • No-load speed at 4.8V: 0.50 sec/60° (20 RPM)
  • No-load speed at 6.0V: 0.40 sec/60° (25 RPM)
  • No-load speed at 7.4V: 0.32 sec/60° (30 RPM)
  • Stall torque at 4.8V: 480 oz-in (34.6 kg.cm)
  • Stall torque at 6.0V: 600 oz-in (43.2 kg.cm)
  • Stall torque at 7.4V: 700 oz-in (50.4 kg.cm)
  • No-load current at 4.8V: 150mA
  • No-load current at 6V: 160mA
  • No-load current at 7.4V: 200mA
  • Stall current at 4.8V: 2000mA
  • Stall current at 6V: 2500mA
  • Stall current at 7.4V: 3000mA
  • Motor type: Brushed DC
  • Direction with increasing PWM signal: Counterclockwise
  • Maximum PWM range: 500-2500µsec
  • Travel per µsec: 0.45°/µsec
  • Maximum rotation: 900° (2.5 turns)
  • Pulse amplitude: 3-5V
  • Deadband width: 4µsec
  • Wire length: 300 mm
  • Wire gauge: 22AWG
  • Connector type: 3-Position TJC8 Servo Connector [MH-FC]